Looking to get into stone polishing? Think stones are simply the very best, however you’re unsure how you can shine them properly? You’ve arrived at just the right place. We’ve got the most beneficial tips on how to be a stone polishing specialist. Whatever phase of rock or gem cutting you begin with, stone polishing certainly is the last stage that makes or breaks your entire work.

1. Grind wet

Always grind moist to safeguard your lungs from inhaling the dirt from stone polishing. The dirt coming from some stones, for instance malachite, is very deadly. Additionally, moist grinding reduces harm to costly diamond wheels and stone polishing equipment.

2. Decide dry

Even though we usually grind moist, it is recommended that you always dry the stone fully before evaluating its surface. Water on the stone surface will simply hide marks and present an incorrect reading. So, you must decide dry during stone polishing.

3. Make use of the entire wheel

Make use of the entire width of the grinding wheel, not merely the very centre. This tends to guarantee a prolonged life and greater effectiveness of the diamond wheel. You must use the wheel entirely during stone polishing.

4. Skip no grit

Work sequentially right from the coarsest toward the finest grit. Don’t attempt to take a quick way by bypassing a grit to save some time. The advancement via finer and finer grits is essential to get rid of the scratches left because of the previous grit. The aim is to have the scratches become finer with each and every grit size until they can not be seen. Our experience continues to be that when a person misses a grit, the ultimate polish can have huge scratches. You may wonder where these scratches simply originated from! The reality is that these were there at all times, however, you simply didn’t sand all of them out while you were meant to. In the event you miss a grit and discover serious scratches, you’ll need to go back three or four grits to eliminate them. It’s generally faster to get it done right the very first time rather than attempt to cut corners and risk damaging the stone you’re perfecting.

5. Polish slow

Stone Polishing will be the last step. There's a number of polish and stone-polishing pad combos; our choice is charging a gentle leather pad with a thin paste of Holy Cow stone polishing substance and water. The specific polishing happens because the pad begins to dry and the stone starts to pull up against the surface. We maintain the speed of the pad at a low to get rid of any heat accumulation.

6. Ensure that it stays clean

Keeping in mind, “Cleanliness is next to Godliness” is particularly important with regards to lapidary work. To avoid cross-contamination from coarse grits, we're careful to wash the stone and our hands at each and every grit change in the course of stone polishing. Additionally, we cleanse our devices after each grinding session to avoid contaminants when moving through grit levels. Stone polishing substances and wheels need to be stored in sealed plastic containers when not being used.