Asphalt shingle roofs usually require very little maintenance if properly installed. However, asphalt shingles can easily be removed and replaced in just seven steps. Although the process is relatively simple. In this article, we will tell you seven steps to roof repairs and recommend you hire professionally trained curling roof shingles contractors.
First Step-Break the tile sealant to be repaired
The first step obviously requires removing the nails that hold the tile on the roof platform. To access the nails, the tile must be raised. But it is likely to be sealed to the lower tile by the points with asphalt sealant. While the adhesive power of this sealant is quite strong (strong enough to resist the force of the wind), it can be broken by sliding a flat bar or lever carefully under the edge of the tile to be repaired.
This separation of the sealant should be done when the weather is cool, as the sealant adhesive can be sheared more easily when it is cold-in a warmer climate, the sealer will be stickier and tougher, and more difficult to separate properly.
Caution: In colder weather, tiles will be stiffer than in a warmer climate. Work carefully to avoid deforming the tiles more than necessary.
Second Step-Break adjacent sealants
Once the sealant adhesive has broken on the target tile, it will be necessary to break the same adhesive on the top tile or tiles. In order to remove them and thus access the nails in the target tile.
Third Step-Remove the nails
Sometimes the nails can be removed by accessing them directly. But often if you try to remove them over the tile the granular surface of the tile can be damaged. Therefore, it is better to lift the tile and the nail at the same time. For this, you will need to access the lower part of the target tile.
Slide the bar or lever to the area of each nail and pry it up on the tile, which will also lift the nail from the platform. Remove the four nails from the target tile.
Fourth Step-Remove the adjacent nails
Once the four nails are removed from the target tile, you will notice that you still cannot remove it. This is because the nails in the upper tiles also penetrate the upper edge of the target tile. The fact that each tile in a roof actually stays in place with two rows of nails, it is is a key factor in the whole wind resistance system of the roofs.
Then, you will need to break the sealant adhesive on the tiles two rows above the target tile as well, and then remove the nails from the tiles in the row immediately above the target tile.
Step Five-Remove the old tile
Now that all the sealant adhesives have been broken and all the nails have been removed, the target tile should be loose and can be removed.
Sixth Step-Placing the new tile
Take the new tile (it has to be the same size as the old one), and slide it. Slice it into place and then re-nail the supra-recumbent tiles where the other nails were previously removed.
Seventh Step-Re-seal the tiles
Finally, did you remember breaking all those sealant adhesives that join tile with tiles? Although the new tile will probably be sealed to adjacent tiles with sufficient heat from the sun. It is recommended to manually seal them to the new tile. Simply apply three small points of asphaltic roofing cement under the tabs of the new tile, spread evenly along the tile, and press the tile into place.
Seal those surrounding tiles whose sealant adhesive may have separated in the same way. This will ensure that the resistance of the roof to the winds will continue as before, uninterrupted.
